Maintenance skills of aluminum alloy doors and win

2022-07-22
  • Detail

Aluminum alloy doors and windows in use, the action should be light, push and pull naturally; If you find it difficult, don't pull or push hard. You should eliminate the fault first. Ash accumulation and deformation are the main reasons for the difficulty of pulling aluminum alloy doors and windows out of the old and out of the new. It is necessary to keep the door frame clean

1. Aluminum alloy doors and windows should be light in use, and push and pull should be natural; If you find it difficult, don't pull or push hard. You should eliminate the fault first. Ash accumulation and deformation are the main reasons for the difficulty of pulling aluminum alloy doors and windows out of the old and out of the new. It is necessary to keep the door frame clean, especially the sliding groove clean. You can use a vacuum cleaner to remove the dust in the groove and the top of the door seal

2. When cleaning aluminum alloy doors and windows, people should not step on the aluminum frame, nor pull the frame as a support

3. Aluminum alloy doors and windows can be dipped with soft cloth with water or neutral detergent. Do not use ordinary soap and washing powder, and do not use detergent with strong acid and alkali, such as decontamination powder and toilet detergent

4. After rainy days, wipe the wet glass and door and window frames in time, and pay special attention to wipe the water in the chute. If the chute is used for a long time and the friction force increases, you can add a little engine oil or apply a layer of wax oil

5. The connecting parts of the aluminum alloy frame should be checked frequently, and the bolts should be tightened in time to replace the damaged parts. The vulnerable parts of aluminum alloy doors and windows such as locating pins, wind braces, ground springs, etc. should be checked frequently and lubricated regularly to keep them clean and flexible

6. The sealing wool and glass sealant are the key structures to ensure the sealing and insulation of doors and windows. If they fall off, they should be repaired and replaced in time

7. Frequently check the junction of aluminum alloy frame and wall. If it is loose over time, it is very easy to deform the whole frame, so that the doors and windows cannot be closed and sealed. Therefore, the screws at the connection should be tightened immediately if they are loose. If the screw footing is loose, it should be sealed with a small amount of cement mixed with epoxy strong glue

北京眼科医院

株洲男科医院

北京银屑病医院

青岛男科医院

Copyright © 2011 JIN SHI